Hello! Well, I have had zbrush for a while now. But just recently really stated to get into it. I started a sculpt of..not really a character. Just a practice design to get the hang of the brushes, masking etc. I still have a long ways to go, I'm just now starting to put some detail into the face and have a few spots that I will change or redo. The horns I have shaped out, but need to detail and set them to their final position. I think my main problem with doing this "demon" was/is the face, I am not the best in anatomy and have had a semi difficult time getting it set right. I wanted to post it on this great forum to see what the people of Zcentral thought of it. Any advice and comments are appreciated!
He's That bad? so bad there is no comments! . Well I got him flushed out a little more and got the horns done. I will try and finish him tomorrow, I have not a clue what to do for the teeth, but Will come to that bridge when I get there. I looked for a help section to ask this but did not find one, When sculpting this guy with more detail, or higher polygon count. I get a bit of lag on the system, I checked my cpu and ram and both are running at less then half With the net open and zbrush running. Assuming this is with the program, what Can I adjust to eliminate the lag? I have not even messed with the zbrush settings other then the "mem" option, which I set to a little over a gig. Not sure If I need to set this higher or not.