ZBrushCentral

My current personal project - contraption

Hi guys, just wanted to share my latest work progressions with you.

This is a steampunky cyborg “drone” I would imagine, or thats the idea :stuck_out_tongue: This concept was my creation, some bits from here and there, thus, isn’t top notch as I’m not as much as a concept artist myself, so, any critiques are very well welcome.

I’ve been modelling him with ZModeler and I’m loving every bit of it, very fun process, I must say, it really challenges your technical creativity some times eheh

I’ll keep posting the progresses

Hope you guys like it

Attachments

wip_06_01.jpg

wip_06_02.jpg

wip_06_03.jpg

wip_06_04.jpg

wip_06_05.jpg

wip_06_06.jpg

Here’s an update on tje weapons, almost done with the blockout stage, getting ready for the good stuff :stuck_out_tongue:

untitled.25.jpguntitled.26.jpguntitled.27.jpguntitled.28.jpguntitled.29.jpg

That is a LOT of detail. :slight_smile: :+1:

Did you make the holes with Split Point, then Alt/QMesh for the new polygroup?

Very nice contraption!

Yeah I used split point to create the holes. idn’t Qmesh them tho. Started doing that but then realized that I would need holes in both sides to Qmesh. just deleted the cylinder caps and extruded it all with the holes already made.

edit: Ohh and many thanks ehehe

Another update before detailing