Hi guys, I work on this Project since a few weeks. When I think its right and ready, I will print it out with my 3D printer. The tricky thing about it is, that I want print out this sculpture with 80 cm height, but my printer can make only 20 cm pieces. So I will cut this sculpture in different pieces and put them together after printing. In a view weeks I will show you the pics from the ready project! I hope you like it.
***The purpose of art is washing the dust of daily life off our souls.***
Pablo Picasso
Udo Graf 3D Artist - 3D Trainer Spielplatzstraße 10
8580 Köflach
Tel. : +43 (0) 660 - 4898633
E-Mail: info@udo-graf.com [/EMAIL]
Web: www.udo-graf.com
Hi ZBrusher!
THX for your comments.
Here are a bit more information about my 3d printings:
My printer is a Wanhao 5s mini, and I always print with PLA.
My glue for the pieces is from beko it names Hpbrid POP. It is very good because you can adjust the pieces a couple of minutes before it is to strong. After that I start it with a filler. If its dry I grind it with an abrasive paper (wet 230).
The next step is to spray a plastic primer. After that a sprayfiller to fill the small stripes from 3d printing. Than I grind it again (wet 230). When the surface is pretty smooth I spray a Bronze effect lacquer. And finally, I seal the whole thing with a clear lacquer.
I hope you can take advantage of it. Here is now my next project pictured. This figure is also modeled by me and becomes 50 cm high.
***The purpose of art is washing the dust of daily life off our souls.***
Pablo Picasso
Udo Graf 3D Artist - 3D Trainer Spielplatzstraße 10
8580 Köflach
Tel. : +43 (0) 660 - 4898633
E-Mail: info@udo-graf.com [/EMAIL]
Web: www.udo-graf.com